|Product Dimensions||11.94 x 9.4 x 3.81 cm; 331 Grams|
|Item Model Number||UT0431-01|
|Is Discontinued By Manufacturer||No|
|Item Package Quantity||1|
|Item Weight||331 g|
|Country of origin||China|
UHPPOTE AC 110-240V to DC 12V 3A Power Supply for Door Access Control Worldwide Voltage
Enhance your purchase
- Worldwide voltage input AC 110 - 240V
- Set NC/NO outputs, can control various types of electric locks
- Compact design and light weight
- Based delay control circuit, lock time can be in 0-15 seconds
- Note: Opening time must set to 0 second when connecting with electric controlled lock. Otherwise electric bolt lock would be Burned Down
Frequently bought together
Have a question?
Find answers in product info, Q&As, reviews
Your question might be answered by sellers, manufacturers, or customers who bought this product.
Please make sure that you've entered a valid question. You can edit your question or post anyway.
Please enter a question.
Compatible with E/M lock, access controller, exit push button and RFID reader
Can reduce the load of access controller, save wiring to reduce the hidden trouble
Set NC/NO outputs, can control various types of electric locks
Based relay control circuit, lock time can be adjusted with 0 -15 seconds
Automatic protection function for dangerous situation: overload / over voltage / short circuit
Protection mechanism: power may be temporarily disconnected or the fuse auto insured
Operative device: E/M Lock, access controller, exit push Button
Compact design and light weight
Worldwide voltage input AC 110 - 240V
Input Voltage: AC 110-240V (Worldwide voltage)
Input Frequency: 50-60Hz
Output Voltage: DC 12V/3A
Load: 1% Typical
Output Stability: 0.5% Typical
Hold Time: Full Load Typically 20ms
Operating Temperature: -20℃~65℃
Adjustable Locking Delay: 0~15sec
Dimensions: 120Lx95Wx38H(mm) / 4.72Lx3.74Wx1.50H(inch)
1 x Power Supply
1 x User manual
Review this product
Top reviews from other countries
Scenario - You have a Normally-Open circuit (e.g., Fail-secure electric door jamb).
100 - 240V AC in is as marked, so the instructions are at least good for this.
If you use a Normally-Open circuit to trigger the unit, the wires in should go to the terminals marked "+NO" and "-Common" (Use +NC if it is a normally closed circuit).
The 12-volt triggered solenoid latch should be wired to "Push" and "Ground"
If you have a +12V trigger to trigger the solenoid, you should use the terminals marked "Control+" and "Control-"
Hope this helps!
I installed it and used it at my video door-bell - electric lock system for one month. One day we experienced electric power outages in my area. This device was the only one that was damaged.
I don't say that a product must be designed to withstand any disturbance at AC input, but the fact that the outages where not that severe and this was the only device affected shows that it has not even the slightest protection at input.
Consider using it with some UPS or some other protection.
Did exactly what i needed to for opening a mag lock controlled wing gate with hydraulic ram
I went away for 2 weeks, worked once on my return then died
I have returned for refund and ordered the same again as a straight swap will save time - lets see how the next one fares